Remote Control Accessories - Copier
Quick Links
Need a Replacement Transmitter?
Need a Transmitter/Receiver Repair?
Telecrane Program Copier (F21, F23, & F24 Crystal Series)
Description:
The F24 copier is a synchronizing (Pairing) device designed for F21 crystal series 2S/D, 4S/D, F23 and and F24 6S/D, 8S/D, 10S/D, 12S/D, and F24-60 Joystick models. The data from the transmitter or receiver can be transferred to the other using this device. It can be used to transfer the data from Tx to Rx, Rx to Tx, Rx to Rx, and Tx to Tx as long as they are the same model. Using a copier is a fast way to synchronize transmitters and receivers.
Three buttons are available on the copier, and each button is capable of storing one set of data at a time.
Previously saved data will be erased automatically once new data is stored.
How to use
Â
Step 1. Battery Installation
Remove four screws on the bottom cover of
copier with Philips screwdriver, and insert 2 AA-size 1.5V Alkaline batteries.
Â
IMPORTANT!
Both the transmitter and receiver’s power must
remain OFF during the reading and writing
process. (Remove the transmitter’s batteries
and disconnect the receiver from the power source).
Â
Step 2. Reading data
Place the magnetic key into the key holder, and do NOT remove it until the reading process is fully completed.
Connect the six-pin cable to the transmitter or receiver. Press and hold the button you wish to store the data, and release it when the green LED stops flashing.
Disconnect the cable when the LED remains OFF completely.
Â
Step 3. Writing data
Remove the magnetic key from the copier’s key holder, and do not put it back until the writing procedure is fully completed.
Connect the six-pin cable to the transmitter or receiver. Press and hold the button you wish to write data to, and release it when the green LED stops flashing.
Disconnect the cable when the LED remains OFF.
Attention!
1- Ensure that the transmitter or receiver you are synchronizing is the same model. Otherwise, the system may not work correctly.
2- Remove the transmitter’s batteries or switch off the receiver’s power during synchronization; otherwise, it may damage the memory.
3- Any of the three buttons can be used for storing and reading the data, but always remember which button was used last to avoid wrong data transfer.
4- Each button only stores the last data copied. The old data will be erased automatically once the new data is stored.
5- Writing empty data may damage the transmitter or receiver.
6- Ensure the six-pin cable is securely connected to the transmitter or receiver before use. A flashing red LED indicates the six-pin cable is not well connected during the reading or writing process.
7- When battery power is low, a yellow LED will flash until the batteries are replaced with new ones.
Caution:
Using a copier for the F21 crystal & F24 series of remote controllers will change the serial number ID Code and the program of the remote controller, but it will not change the frequency (Channel number).
After successfully using the copier to make the required changes and pair the systems, proper labels with the correct ID Code and Channel number must be printed and attached to the Tx or Rx.
